Passiflora: Drone Survey Identifies Three Near-Surface Conductive Targets Above 843.9-Metre Gold-Copper Intercept

Viscount Mining has completed a high-resolution, drone-based semi-airborne electromagnetic (SAEM) survey by Rosor Exploration Corp. over the Passiflora target at its Silver Cliff Project. The survey independently confirms the conductive system previously mapped by Quantec Geoscience’s magnetotelluric (MT) survey and resolves three distinct low-resistivity zones within approximately 500 metres of surface.

Three lines of evidence, one target

  • Drilling: Hole PF-23-03A intersected 843.9 metres of continuous gold-copper mineralization grading 0.2143% copper-equivalent*, beginning at approximately 400 metres downhole.
  • Quantec MT survey: A large conductive anomaly extending from approximately 400 metres to more than 1,500 metres below surface over about 6 square kilometres, open at depth.
  • Rosor SAEM survey: 105 flight lines (about 190 line-kilometres) over 3.5 km², modelled to approximately 500 metres depth. Three upper conductive zones – Passiflora West, Central and East – were resolved, with the Central zone lying directly above the PF-23-03A intercept.

Next steps

Viscount is planning a fully funded Phase Two diamond drilling program of three deep holes at Passiflora, each planned to approximately 1,500 metres (about 5,000 feet). Collar locations will be selected by integrating the three Rosor targets with Quantec’s 3D MT model, PF-23-03A results, soil geochemistry and surface mapping. Specific targets and the mobilization schedule will be announced once planning is complete.

Read the full news release →


*Copper-equivalent grade as previously reported by the Company on August 14, 2024; see that release for metal price and recovery assumptions.

Cautionary note: Conductive anomalies may be caused by sulfides, clay or fluids and are not necessarily indicative of economic mineralization. This page contains forward-looking statements, including statements regarding planned drilling and the interpretation of geophysical results, which are subject to risks and uncertainties. Actual results may differ materially. Readers should refer to the full news release and the Company’s filings on SEDAR+ for additional information.

Qualified Person: The scientific and technical information on this page has been reviewed and approved by Harald Hoegberg, C.P.G., an independent consulting geologist and a Qualified Person as defined under NI 43-101.